Generac — SECTION 2: IGNITION

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. 1. Insert RED test lead into ¥n* receptacle in meter.
2. 2.Insert BLACK test lead into the “COM” receptacle in meter.
3. 3.Rotate selector to >I! (Diode Test) position.
4. 4 Insert RED test lead clip into connector “A" (black wire), Fig.
5. Ney
6. f \

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.