Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SECTION 2: IGNITION

Generac — SECTION 2: IGNITION

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Note: CLEAN flywheel and crankshaft taper removing all

Procedure

  1. 1. Assemble flywheel to crankshaft and align keyways.
  2. 2.Insert flywheel key into crankshaft.
  3. |
  4. L vq)
  5. 3. Assemble fan and retainer to flywheel, Fig. 7.
  6. a. Torque screws to 140 in. lbs. (16.0 Nm).

Specs & torque values

  • a. Torque screws to 140 in. lbs. (16.0 Nm).

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.