Generac — Procedure 6

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. 2. Power from the transfer switch load terminals Is
2. used to operate a 7-day exerciser circuit on the
3. CMA circuit board.
4. C. 23 and 194
5. 1. Connect to identically numbered terminals on
6. the terminal board of the prepackaged transfer
7. switch.
8. 2. This circuit connects the CMA circuit board to
9. the transfer relay coil in the prepackaged transfer
10. TERMINAL
11. / BOARD
12. ° Hepeieeree of 0

Source: manual:83045.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.