Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›{. See Figure 6. Remove two (2) screws that retain the

Generac — {. See Figure 6. Remove two (2) screws that retain the

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

  1. 2. Loosen- DO NOT REMOVE- the wire retaining
  2. screws at back of terminal strip. Remove all wires and
  3. remove the terminal strip.
  4. 1. See Figure 7. Remove four capscrews that retain the
  5. coil backing plate. Also remove the capscrew that
  6. retains the solenoid coil to the backing plate.
  7. Page 5.5-2
  8. Figure 7. Solenoid Coil Removal
  9. 1. See Figure 11. Remove the spring retaining pin.
  10. WHITE 2. See Figure 12. Remove two (2) screws that retain
  11. 4 the actuating link assembly to the transfer mechanism
  12. base.

Source: manual:83045.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.