Generac — UMIT SWITCH LS3 REMOVAL:

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. 2. Rotate the coil slightly to allow access to the coil
2. terminal screws. Remove the terminal screws and dis-
3. connect the coil red and white wires.
4. 3. Remove the solenoid coil along with the coil cylinder.
5. YELLOW
6. ORANGE
7. J BLUE
8. GREEN
9. : J BROWN
10. BLACK
11. y

Source: manual:83045.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.