Generac — DISASSEMBLY, TESTING, REASSEMBLY

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. 3. Turn OFF all power voltage supplies to the transfer
2. switch, -sing whatever means provided (such as the
3. "Utility" and "Standby" main fine circuit breakers).
4. 4. Disconnect all wires from transfer mechanism ter-
5. minal tugs N1, N2, T1, T2, E1, £2.
6. 5. Disconnect all wires from transfer mechanism ter-
7. minals Al, A2, B1, Be.
8. 6. Remove the M5-0.80 capscrews, lockwashers and
9. flatwashers that retain the transfer mechanism in the
10. enclosure. Then, remove the transfer mechanism.
11. Electrical Section Disassembly
12. 1. Remove two (2) screws that retain the outer cover to
13. the transfer mechanism (Figure 2).
14. \a_taah
15. | a
16. J) BH
17. Figure 2. Outer Cover Removal
18. 2. Remove four (4) screws that retain the inner cover
19. (Figure 3).
20. Figure 1. Transfer Mechanism Removal

Source: manual:83045.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.