Generac EcoGen 6kW Generator / GT-530 — Adjusting GT-530 Valve Clearance
Adjustments · Engine valve train
For the Generac EcoGen 6kW Generator / GT-530, from the Generac owner's manual.
Applies to: Generac EcoGen 6kW Generator, Generac GT-530 engine, Generac GT-530 engine
Before you start
- Contact dealer if uncomfortable performing this procedure or lacking proper tools
Procedure
- Remove spark plug wires and spark plugs
- Rotate the flywheel clockwise to bring the piston to Top Dead Center of compression stroke
- Remove the four valve cover screws and the valve cover
- Loosen the rocker jam nut and turn the pivot ball stud while checking clearance with a feeler gauge
- Set clearance to 0.002-0.004 inch (0.05-0.1 mm) and hold pivot stud while tightening jam nut to 174 in/lbs
- Recheck clearance after tightening
- Install a new valve cover gasket and reattach the valve cover
- Reinstall spark plugs and reattach spark plug wires
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Valve clearance 0.002-0.004 inch (0.05-0.1 mm)
- Jam nut torque 174 in/lbs
Full service-parts list: Generac EcoGen 6kW Generator →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.