Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›D)

Generac — D)

For these Generac models: EcoGen 6kW Generator, GT-530.

Applies to: Generac Ecogen 6Kw Generator, Generac Gt 530

Procedure

  1. 7. Set the AUTO/OFF/MANUAL switch to AUTO. The system is now ready for automatic operation.
  2. 8. Close or connect Remote 2-wire Start with a test switch installed at the inverter. With the AUTO/OFF/MANUAL switch at AUTO, the engine should crank and start when the remote start contact switch is closed. Let the system go through its entire automatic sequence of opera- tion. With the generator running and loads powered by generator AC output, and the remote start contacts OPEN. The following should occur: About one minute after remote start contacts OPEN (OFF) the • engine should shut down.
  3. 3.1 CONTROL PANEL INTERFACE
  4. 3.1.1 USING THE AUTO/OFF/MANUAL SWITCH (FIGURE 3.1) n With the switch set to AUTO, the engine may crank and start at any time without warning. Such automatic starting occurs when utility power source voltage droops below a preset level or during the normal exercise cycle. To prevent possible injury that might be caused by such sudden starts, always set the switch to OFF and remove the fuses before work- ing on or around the generator or transfer switch. Then, place a “DO NOT OPERATE” tag on the generator panel and on the trans- fer switch.
  5. 1. “AUTO” Position – Selecting this switch activates fully auto- matic system operation.
  6. 2. “OFF” Position – This switch position shuts down the engine. This position also prevents automatic operation.
  7. 3. “MANUAL” Position – Set the switch to MANUAL to crank and start the engine. Transfer to standby power will not occur unless there is a utility failure. Operation

Source: manual:696471058185_use.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.