Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Cylinder Leak Down test procedure:

Generac — Cylinder Leak Down test procedure:

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • NOTE: If leaking into intake or exhaust port, check lash,

Procedure

  1. Piston must be at TDC.
  2. Install the tester into the spark plug hole
  3. Pressurize the cylinder to 90 psi.
  4. Observe the leakage of the cylinder and where the air is coming from.

Source: manual:0C1103A.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.