Generac — Connecting SACM
Installation · Smart A/C Module (SACM)
From a Generac service manual covering: RTSC400A3, RTSW300A3, RTSW400A3. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Route the thermostat cable from the furnace/thermostat to the outdoor air conditioner unit to the transfer switch.
- Connect the wire to the terminal strip terminals (A/C 1) on the SACM.
- These are normally closed contacts which open upon load shed conditions.
- Route thermostat wire away from high voltage wires.
- If required, connect additional air conditioners to the terminal strip terminals (A/C 2-4).
Specs & values
- A/C 1-4 contact ratings: 24 VAC, 1.0 Amp max
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.