Generac — Connecting Battery Power Cables
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Never reach into port or touch battery terminals with hands or tools.
Procedure
- Remove gray rubber cap (A) from each module power port.
- Plug black power cable connectors into battery module power ports (B).
- Install loop jumper (C) on every unused power cord connector (D).
- Tie unused loop jumpers (E) to wiring chase baffle slot (F) for future use.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.