Generac — Connect LP Hose
Installation · LP Fuel System
From a Generac owner's manual covering: IQ5200DF, iQ3800, iQ3800 DF, iQ5200. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- If a leak exists, this must be corrected before using generator.
Procedure
- Remove safety plugs or caps from cylinder valve, generator mounted regulator, and regulator connecting hose ends.
- With LP tank closed, attach LP regulator connecting hose into valve; turn plastic coupling clockwise to tighten.
- Compress the slidable sleeve on the quick connector to Compressed state and plug the quick connector into LP inlet on control panel; release sleeve to Release state.
- Turn LP tank valve ON and check for leaks by spraying soapy water on connections.
Specs & values
- LP vapor 1st stage regulator inlet pressure approximately 30 psi at 0 °F and 218 psi at 100 °F
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.