Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›GOVERNOR

Generac — GOVERNOR

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Note: Intake push rods are aluminum.

Procedure

  1. Loosen governor lever nut. a. Remove governor lever from shaft, Fig. 6.
  2. Remove oil pump. Fig. 7. a. Remove oil pump cover. b. Remove inner rotor. c. Remove outer rotor. d. Remove drive shaft. 14
  3. Remove sump and discard gasket, Fig. 8. a. Remove governor gear and thrust washer

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.