Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SCREW DRIVER

Generac — SCREW DRIVER

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Start and run engine running at top no load speed and note
  • be readily apparent. Now note RPM of engine. Ground out one
  • tion tester and a good ground on engine, Fig. 9. Note RPM

Procedure

  1. Two Ignition Testers (Generac P/N 0C5969)
  2. Screwdriver with insulated handle Attach an ignition tester between the spark plug lead and each spark plug, Fig. 8.

Tools required

  • Tools Required:

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.