Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SET PLUG GAP AT 0.030 inch

Generac — SET PLUG GAP AT 0.030 inch

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

  1. Place the flywheel on a wooden surface.
  2. Hold a screwdriver at the extreme end of its handle and with its point down.
  3. Move the tip of the screwdriver to about 3/4 inch (19mm) from the magnet. The screwdriver blade should be pulled in against the magnet.

Specs & torque values

  • (0.76 mm)

Source: manual:0C1103A.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.