Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›CLEANER ASSEMBLY OR AIR CLEANER CARTRIDGE

Generac — CLEANER ASSEMBLY OR AIR CLEANER CARTRIDGE

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Note: Replace air cleaner gaskets and mounting gaskets
  • Note: The air cleaner assemblies on some equipment

Procedure

  1. Will not start
  2. Hard starting
  3. Lack of power
  4. Runs rough
  5. Vibration
  6. Overheating
  7. High oil consumption Note: What appears to be an engine malfunction may be a fault of the powered equipment rather than the engine. If equipment is suspect, see equipment affecting engine operation.
  8. Fuel
  9. Ignition
  10. Compression This check-up, performed in a systematic manner, can usually be done in a matter of minutes. It is the quickest and surest method of determining the cause of failure. The basic check-up procedure is the same for all engine models, while any varia- tion, by model, will be shown under the subject heading.

Source: manual:0C1103A.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.