Generac — Changing the Engine Oil
Maintenance
From a Generac owner's manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Hot oil may cause burns; allow engine to cool before draining
Procedure
- Start engine via MANUAL and run until warmed up, then shut off
- Pull oil drain hose free of zip-tie, remove cap, drain oil
- Replace cap on drain hose, retain in zip-tie
- Remove old oil filter turning counterclockwise
- Apply light coat of clean oil to new filter gasket
- Screw on new filter by hand then tighten 3/4 to 1 turn more
- Refill with recommended oil per capacity spec
- Start engine, run 1 minute, check for leaks
- Shut down, recheck level, add as needed
- Reset AUTO/OFF/MANUAL switch to AUTO
Specs & values
- Tighten filter 3/4 to 1 turn after gasket contact
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.