Generac — Change Engine Oil

Maintenance

From a Generac owner's manual covering: IQ5200DF, iQ3800, iQ3800 DF, iQ5200. Check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. Place generator on a level surface.
2. Using a Phillips head screwdriver, loosen the four screws (A) of the service door.
3. Lift bottom of rubber fuel diverter (B) to expose door tab and remove door.
4. Disconnect the spark plug wire from the spark plug.
5. Clean area around oil fill.
6. Remove oil drain hose (A) from door clip.
7. Remove oil drain cap (B) from end of oil drain hose and drain oil into a suitable container.
8. Once oil is sufficiently drained, install and tighten oil drain cover (B).
9. Wipe up any spilled oil; replace oil drain hose (A) into door clip.
10. Remove oil fill cap and insert funnel into oil fill opening; add recommended engine oil as necessary.
11. Remove funnel, insert dipstick into oil filler neck without screwing it in, and verify oil level is within safe operating range.
12. Install oil fill cap/dipstick and hand-tighten.
13. Install service door and tighten the four door screws.
14. Wipe up any spilled oil and dispose of oil in accordance with applicable regulations.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →