Generac — Automatic Choke Adjustment
Adjustments · Carburetor choke
From a Generac service manual covering: IM100G, IM80G, NP100G, NP80G. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Loosen CHOKE SOLENOID adjusting screws.
- Adjust choke position so that, with the solenoid pulled in (energized), the choke plate is closed.
- With choke plate closed, tighten the adjusting screws.
- With solenoid extended, bend tip of the bi-metal until choke plate is about 1/8 inch from vertical and towards the closed position.
Specs & values
- Choke plate about 1/8 inch from vertical with solenoid extended
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.