Generac ASPAS1CCL015 — Weekly Exercise Cycle Setup
Operation · Control panel / exercise timer
For the Generac ASPAS1CCL015, from the Generac owner's manual.
Browse Generac generators & specs →
Before you start
- If the AUTO/OFF/MANUAL switch is switched too soon, the engine may start. If engine does start, it will shut down automatically in about two (2) minutes.
Procedure
- Set the AUTO/OFF/MANUAL switch to OFF.
- Set generator main circuit breaker to OFF or OPEN.
- Locate the rocker switch on the control panel identified as Set Exercise Time.
- Push Set Exercise Time switch to ON position for 20 to 30 seconds and then release.
- Wait 30 seconds before setting the AUTO/OFF/MANUAL switch to AUTO position.
- Set the generator main circuit breaker to its ON or CLOSED position.
- Place a sign on the generator control panel and transfer switch indicating the exercise day and time.
Specs & values
- Runs about 20 minutes and shuts down; transfer of loads does not occur during exercise
- If battery terminals are disconnected, the exercise timer needs to be reset
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.