Generac — Adjust Belt Tension and Generator Springs
Adjustments · drive belt / lower bearing carrier
From a Generac service manual covering: 9202-1, 9203-1, 9204-1, 9205-1, 9206-1, 9207-1, 9290-2, 9509-2, 9592, 9593-0, 9593-1, 9593-2…. Check it applies to your exact model before use.
Applies to: Generac 9592
Procedure
- Turn the two adjusting cap screws to change drive belt tension.
- Adjust until the compressed length of the two belt tension springs is 5/8 inch (16 mm).
- Turn the adjusting bolts to set the four lower bearing carrier springs to a compressed length of 7/8 inch (22 mm).
Specs & values
- Belt tension springs compressed length 5/8 inch (16 mm)
- Carrier springs compressed length 7/8 inch (22 mm)
Full service-parts list: Generac 9592 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.