Generac 9344 — Rear Bearing Carrier Removal (Units with 15 Inch Stator)
Repair & overhaul
For the Generac 9344, from the Generac service manual.
Applies to: Generac 9344
Procedure
- Remove hex nuts, lockwashers and studs that retain the rear bearing carrier.
- Use a soft mallet to tap around the outer periphery of the bearing carrier.
- Continue tapping until the bearing carrier is free of the rotor bearing.
Tools required
- Soft mallet Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac 9344 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.