Generac 9344 — Brush Access and Removal (Units with 15 Inch Stator)

Repair & overhaul · Brush holders and brushes

For the Generac 9344, from the Generac service manual.

Applies to: Generac 9344

Procedure

1. Remove the taptite screws that retain the two brush covers to the rear bearing carrier.
2. Remove the brush covers to gain access to the brush holders.
3. Remove Wires No. 1 and 4 from the brushes in both brush holders.
4. Remove the taptite screws that retain the brush holders to the rear bearing carrier.
5. Remove both brush holders, along with the brushes.

Full service-parts list: Generac 9344 →

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →