Generac 6.8 L / QT 130kW — Spark Plugs - Clean, Gap or Replace
Maintenance
For the Generac 6.8 L / QT 130kW, from the Generac owner's manual.
Applies to: Generac V-type engine
Procedure
- Clean area around base of spark plugs to keep dirt and debris out. Do not blast the spark plugs.
- Remove the spark plugs and check condition. Replace if worn or reuse is questionable.
- Check gap using a wire feeler gauge. Adjust gap to 1.14 mm (0.045 inch) by bending ground electrode.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Spark plug gap 1.14 mm (0.045 inch)
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.