Generac 2.4 L / 60kW 1.5L — Fuel Conversion Procedure from NG to LPV
Adjustments · Demand Regulator Assembly
For the Generac 2.4 L / 60kW 1.5L, from the Generac owner's manual.
Applies to: Generac 2.4 L, Generac 2.4L engine, Generac 1.5L engine
Before you start
- Fuel conversion software is password protected
- Failure to convert both hardware and software violates EPA regulations
Procedure
- Turn off the main gas supply.
- Remove battery negative cable (black) from battery negative (-) terminal.
- Remove carburetor fuel hose from outlet port.
- Remove screw at front of power wire connector and pull connector from fuel solenoid.
- Expand spring clamp on fuel enrichment hose and remove from hose barb.
- Remove black pipe assembly from outlet port; remove fuel solenoid assembly if clearance is insufficient.
- Rotate NG fuel jet counterclockwise to remove from outlet port.
- Rotate LP fuel jet counterclockwise to remove from jet keeper port.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- LP fuel jet installed in outlet port; NG fuel jet installed in jet keeper port
Full service-parts list: Generac 2.4 L →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.