Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SHAFT:

Generac — SHAFT:

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

  1. Check governor cup and thrust washer for damage or wear.
  2. Assemble governor shaft to sump to act as a pilot for bush- ing.
  3. Using Briggs & Stratton Tool P/N 19129, press in bushing until it bottoms, Fig. 13.
  4. Install lower E-ring. a. Install new oil seal. #19129

Tools required

  • 2. Using Briggs & Stratton Tool P/N 19129, press in bushing until

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.