Generac 006000-0 — Assembling the Accessory Kit
Installation · Wheels, frame foot, tank bracket, tank shroud
For the Generac 006000-0, from the Generac owner's manual.
Browse Generac generators & specs →
Before you start
- The wheels are not intended for over-the-road use.
Procedure
- Slide the Axle Pins through the Wheel, 1/2" Flat Washer, and Wheel Bracket on the frame.
- Insert the Cotter Pin through the Axle Pin then bend the tabs outward to lock into place.
- Slide the Rubber Bumper studs through the Frame Foot then install the Locking Flange Nuts.
- Slide the Hex Head Bolts through the holes in the Frame Rail.
- Slide the Frame Foot onto the Hex Head Bolts then install the Locking Flange Nuts.
- Remove hex nuts from lower panel on each side at rear; push Flathead bolts back and align holes with bolts.
- Slide long Bolts through the Tank Bracket and Cradle, then install the Hex Nuts.
- Slide tank shroud tab ends between tubes in rear of cradle.
- Insert M8 Bolts (long) through tubes and into threaded inserts.
Tools required
- Needle Nose Pliers Amazon
- 10mm, 12mm, 13mm sockets Amazon
- Ratchet Amazon
- 10mm, 12mm, 13mm wrenches Amazon
- 5mm Allen wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.