Generac 006000-0 — Adding Engine Oil
Operation
For the Generac 006000-0, from the Generac owner's manual.
Browse Generac generators & specs →
Before you start
- Any attempt to start the engine before it has been properly serviced with the recommended oil may result in an engine failure.
Procedure
- Place generator on a level surface.
- Clean area around oil fill; remove oil fill cap and dipstick.
- Wipe dipstick clean.
- Slowly fill engine with oil through oil fill opening until it reaches the full mark; stop occasionally to check level.
- Be careful not to over fill.
- Install oil fill cap and finger tighten securely.
- Check engine oil level before starting each time thereafter.
Specs & values
- Oil capacity 0.6 L (0.63 Qts.)
- Above 40°F use SAE 30; below 40°F to 10°F use 10W-30 Amazon eBay $54.99; below 10°F use synthetic 5W-30 Amazon eBay $47.95
- All oil must meet API Service Class SJ, SL or better
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.