Generac 005219-0 — Changing Engine Oil
Maintenance · Engine crankcase
For the Generac 005219-0, from the Generac owner's manual.
Applies to: Generac V-type engine
Before you start
- After refilling the crankcase with oil, always check oil level on dipstick. NEVER OPERATE ENGINE WITH OIL BELOW THE DIPSTICK ADD MARK.
- Drain the oil while the engine is still warm from running.
Procedure
- Remove OIL DRAIN HOSE from its retaining clip.
- Loosen and remove OIL DRAIN HOSE CAP; drain oil completely into suitable container.
- Install and tighten OIL DRAIN HOSE CAP, re-install into retaining clip.
- Turn OIL FILTER counterclockwise and remove; dispose of old filter.
- Apply light coating of new engine oil to seal of new oil filter; install and tighten by hand only.
- Remove OIL FILL CAP; add recommended oil; do not fill above dipstick FULL mark.
- Start engine and check for oil leaks.
Specs & values
- Crankcase oil capacity is 4.0 U.S. quarts (3.8 liters)
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.