GAC — Connecting Actuator Linkage to Fuel Rack
A GAC service procedure — check it applies to your exact model before use.
Browse GAC generators & specs →
Before you start
- T
- h
- e
- l
- i
- n
- k
- a
- g
- e
- i
- s
- p
- r
- e
- s
- e
- t
- t
- o
- a
- s
- p
- e
- c
- i
- f
- i
- c
- l
- e
- n
- g
- t
- h
- a
- n
- d
- l
- o
- c
- k
- e
- d
- .
- A
- n
- y
- a
- d
- j
- u
- s
- t
- m
- e
- n
- t
- o
- f
- r
- a
- c
- k
- t
- r
- a
- v
- e
- l
- m
- u
- s
- t
- b
- e
- m
- a
- d
- e
- u
- s
- i
- n
- g
- t
- h
- e
- s
- l
- o
- t
- o
- n
- t
- h
- e
- a
- c
- t
- u
- a
- t
- o
- r
- l
- e
- v
- e
- r
- .
- T
- h
- i
- s
- i
- s
- c
- o
- m
- p
- l
- e
- t
- e
- d
- a
- f
- t
- e
- r
- t
- h
- e
- a
- c
- t
- u
- a
- t
- o
- r
- i
- s
- m
- o
- u
- n
- t
- e
- d
- t
- o
- t
- h
- e
- f
- u
- e
- l
- p
- u
- m
- p
- .
Procedure
- From the KT295 kit, select the P9 [15 mm] or P10 [14 mm] fuel rack adapter and the socket head screw.
- Align the fuel rack adapter over the connecting screw hole of the fuel control rack.
- Apply Loctite Thread Retention Compound to the socket head screw. Using the socket head screw, connect adapter to fuel control rack and torque to 5.8 - 6.2 lbf\u00b7ft [7.8 - 8.4 N\u00b7m].
- Connect the linkage extension from kit KT295 to the end of the fuel rack adapter using the M5-16 hex-head screw and washer, and torque to 3.4 - 3.8 lbf\u00b7ft [4.6 - 5.1 N\u00b7m].
Tools required
- Socket head screw
Specs & torque values
- Fuel rack adapter: P9 [15 mm] or P10 [14 mm]
- Socket head screw torque: 5.8 - 6.2 lbf\u00b7ft [7.8 - 8.4 N\u00b7m]
- M5-16 hex-head screw torque: 3.4 - 3.8 lbf\u00b7ft [4.6 - 5.1 N\u00b7m]
Source: manual:295-Series Pump Mounted Actuator with Position Feedback Sensor.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.