FPT / IVECO — Service Procedure
A FPT / IVECO service procedure — check it applies to your exact model before use.
Browse FPT / IVECO generators & specs →
Before you start
- Provide tank with sufficient capacity to contain the
- the oil filter contains inside aprx. 1 kg. of
- engine oil.
- in case of skin contamination rinse in running water.
- liquid.
- engine oil. Provide for oil recovery and disposal in
- in case of skin contamination, rinse in running water.
- compliance with the law and regulations in force.
- avoid contact of engine oil with the skin:
Procedure
- 45 litres of engine oil
- Injection pump - 2. Fuel outlet to filter - 3. Feed pump - 4. Fuel inlet from tank - 5. Manual control lever.
- Air bleeding screws - 2. Fuel filter support - 3. Temperature sensor - 4. Filtering cartridge - 5. Heater.
- 5 : 1
- 2
- 8
- 5 : 1
- 2
- 8
- 5:1
- 2
- 8
- 5:1
- 2
- 8
- 5 : 1
- 70
- 50
- 5 : 1
- 70
- 50
- 5:1
- 70
- 50
- 5:1
- 70
- 50
- 5 : 1
- 2
- 8
- 5:1
- 70
- 50
- 5:1
- 70
- 50
Tools required
- is delivered to the pressure gauge valve within feed
- specific tooling and equipment required.
- shall be disassembled using tool 99360076.
- Using tool 99360076 operate on oil filter
Source: manual:NEF_repair_manual_F4.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.