Ford WSG-1068 — Radiator Hose - Installation

Repair & overhaul

For the Ford WSG-1068, from the Ford service manual.

Browse Ford generators & specs →

Procedure

1. Position the clamps at least 1/8 inch from each end of the hose.
2. Coat the connection areas with an approved water-resistant sealer and slide the hose on the connection.
3. Make sure clamps are beyond the bead and centered on the clamping surface.
4. Tighten the clamps.
5. Fill the radiator with recommended permanent antifreeze and water 50/50 mixture.
6. Operate the engine several minutes, then check the hoses and connections for leaks.

Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ford repair guides →