Ford — Valve Cover and Gasket Installation
Maintenance
From a Ford service manual — check it applies to your exact model before use.
Browse Ford generators & specs →
Procedure
- Clean valve cover and valve cover gasket surface on cylinder head.
- Put valve cover gasket in place on cylinder head.
- Install valve cover and alternately tighten bolts to 9-13 N·m (84-120 lb-in).
- Snap ignition wiring harness and ignition cables back into place in brackets attached to valve cover.
- Install oil filler cap if removed.
- Start engine and check for leaks.
Specs & values
- Valve cover bolts 9-13 N·m (84-120 lb-in)
Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.