Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Use 24 Ibs-in. (2.7 Nmm) torque when tightening nuts on F1+ and

Ford ES — Use 24 Ibs-in. (2.7 Nmm) torque when tightening nuts on F1+ and

For the Ford ES.

Browse Ford generators & specs →

Procedure

  1. 1. Using high scale on ohmmeter, connect ohmme-
  2. 1. Connect one ohmmeter lead to each end of diode
  3. 2. Reverse ohmmeter leads and again observe re-
  4. 3. Replace defective diodes with new, identical

Specs & torque values

  • CR13and CR16, control the DC output voltage to the
  • on the voltage regulator and are tested as follows:
  • should be one megohm or greater. Reverse ohm-

Source: manual:0900-0335_Service Manual Ford Engine Detector I1_198207.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.