Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Installation of Water Heater Return Tube

Ford WSG-1068 — Installation of Water Heater Return Tube

For the Ford WSG-1068.

Browse Ford generators & specs →

Procedure

  1. 1. Lightly lubricate the o-rings prior to installing the water outlet tube.
  2. 12.42 x 1.8 #W704593-S100 O-RINGS 05-12 WSG-1068 COOLING SYSTEM Cylinder Head Temperature (CHT) Sensor
  3. 1. Remove the upper and lower intake manifold together. For additional information, refer to Section 01.
  4. 2. Remove the cylinder head temperature (CHT) sensor.
  5. 1. Disconnect the electrical connector.
  6. 2. Remove the CHT sensor.
  7. 3. To install, reverse the removal procedure. CAUTION: Do not over torque. May damage sensor. !

Source: manual:WSG1068 Sec. 05 Cooling.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.