Ford WSG-1068 — Removal of Heater Water Inlet Tube

For the Ford WSG-1068.

Browse Ford generators & specs →

Procedure

1. 1. Drain the cooling system.
2. 2. Remove the upper and lower intake manifold together. Refer to Section 01 for details.
3. 3. Remove the two studs securing the tube to the rear of the right side cylinder head and remove the tube.
4. 4. Inspect the water pump tube assembly o-rings for damage.
5. 2. Install the heater wa

Source: manual:WSG1068 Sec. 05 Cooling.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.