Ford — Starter Motor Installation
Installation
From a Ford service manual — check it applies to your exact model before use.
Browse Ford generators & specs →
Procedure
- Position starter motor to engine and install upper and lower bolt finger-tight.
- Tighten the upper bolt to 21-27 N-m (15-20 ft-lb). Access to upper bolt is with a 3/8 inch drive ratchet, swivel socket and a 22 inch long extension.
- Tighten the lower bolt to 21-27 N-m (15-20 ft-lb).
- Connect starter solenoid connector. Push straight on and make sure connector locks in position with a notable click or detent.
- Install starter cable nut to starter terminal. Tighten to 9-13 N-m (80-120 in-lb).
- Replace red solenoid safety cap.
- Connect negative battery ground cable.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Upper bolt: 21-27 N-m (15-20 Amazon eBay FridayParts $130.18 ft-lb)
- Lower bolt: 21-27 N-m (15-20 Amazon eBay FridayParts $130.18 ft-lb)
- Starter cable nut: 9-13 N-m (80-120 in-lb)
Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.