Ford — SIDE WEAR PAD

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. Secure one end of wire ropes in place on tip boom (fourth stage) with extend rope anchor. return cable anchor.
2. With tip boom base-end wear pads in place, slide tip boom and wire ropes into outer mid boom (third stage).
3. Slide tip boom into outer mid boom (third stage); then, install rear wear pads onto outer mid boom (third stage). To install bottom wear pads, lift tip boom.
4. With wire ropes attached, slide telescope cylin- der into outer mid boom (third stage). Install retract rope guides and extend/ retract cable anchor along with wire ropes.
5. While supporting telescope cylinder, install outer mid boom (third stage).

Source: manual:89-103317.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.