Ford — Replacer T74P-6150-A and press into place.

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. 8. Remove tool.
2. 9. Check camshaft end play as outlined in the
3. 10. Position camshaft sprocket on camshaft.
4. 11. Install Cam Sprocket Holding/Removing Tool
5. 12. Install sprocket bolt and washer. Tighten to 70-95
6. 13. Remove tool.
7. 02-62
8. 02-62
9. 14. Install valve lash adjusters.
10. 15. Install one valve and check valve runout,
11. 18. Remove seal protector (plastic cap). Use Valve
12. 16. Put valve seal protector (plastic installation cap)
13. 17. Start valve stem seal carefully over cap. Push
14. 19. Apply a small amount of Ford Multi-Purpose
15. 20. Put valve spring and valve spring retainer into
16. 21. Compress valve spring with Valve Spring
17. 02-63
18. 02-63
19. 22. Check installed height of valve spring assembly:
20. 23. Repeat steps 15 through 22 until all valves are

Source: manual:FORD LRG425 Service Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.