Ford — Replace Drive Loop Hydraulic Filter
Maintenance · Hydraulic system
From a Ford service manual covering: 2WD, 4WD, Genie S-40. Check it applies to your exact model before use.
Browse Ford generators & specs →
Before you start
- Hot oil may cause severe burns.
- Perform with engine off.
Procedure
- Open engine side turntable cover, locate filter.
- Rotate filter housing counterclockwise and remove.
- Remove filter element from housing.
- Inspect housing seal, replace if necessary.
- Install new filter 20880, hand tighten housing.
- Start engine and inspect for leaks.
Specs & values
- Filter part no. 20880 KuduParts $34.00
Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.