Ford — Removal of Throttle Body Assembly

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. 1. Remove three bowl to body screw and lockwasher assemblies (33) and (32).
2. 2. Raise throttle body slightly and separate bowl to body gasket (24) from fuel bowl.
3. 3. Lift off throttle body assembly being careful not to damage floats. Disassembly of Throttle Body
4. 1. With throttle body inverted, remove float axle (22) by press- ing against end of float axle at slotted end of hinge bracket, using screwdriver.
5. 2. Remove of 21). float assembly (23) and fuel valve needle

Source: manual:ford_vsg411_vsg413_shop_opm.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.