Ford — Removal

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. 1. Disconnect
2. 2. Remove and the gasket. Discard the pump attaching screws, the gasket. the inlet and outlet lines at the fuel pump. then remove the pump Installation
3. 1. Remove all the gasket material from the mounting pad and sealer to both sides of a new pump flange. Apply oil-resistant gasket and to the threads on the attaching bolts.
4. 2. Position the new gasket on the pump flange and hold the pump in position against the mounting pad. Make sure the rocker arm is riding on the camshaft eccentric. (Turn engine over is on the low side of the stroke.) until the fuel pump eccentric the attaching tight against
5. 3. Press the pad, install the pump screws and alternately tighten them to specification.
6. 4. Connect
7. 5. Operate the fuel inlet and outlet lines. the engine and check for leaks.

Source: manual:ford_vsg411_vsg413_shop_opm.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.