Ford — Regulator - Removal

Repair & overhaul · Voltage Regulator

From a Ford service manual — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. Remove the generator from engine as described in Generator - Removal.
2. Remove the four screws (T20 Torx type head) attaching the voltage regulator to the generator housing.
3. Remove the voltage regulator with generator brush holder (10351) attached, from the generator.
4. Hold the voltage regulator in one hand and pry off the cap covering the A screw head with a screwdriver.
5. Remove two screws (T20 Torx type head) attaching the regulator to the generator brush holder.
6. Separate the regulator from generator brush holder.

Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ford repair guides →