Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Redistribution or publication of this document

Ford ES — Redistribution or publication of this document

For the Ford ES.

Browse Ford generators & specs →

Procedure

  1. 1. Locate terminals 7(-) and 8(+) on voltage
  2. 2. Use a six volt dry cell battery with two clip leads
  3. 3. After starting engine, touch positive (+) battery
  4. 1. Disconnect all leads from-assembly to be tested.

Specs & torque values

  • voltage should be at least 20 VAC at rated speed. If
  • residual is too low and the output voltage will not
  • and a 12amp,300voltdiodeasshown in Figure6.
  • If a six volt battery is not available, a 12 volt auto-
  • motive battery can be used by adding a 20-ohm

Source: manual:0900-0335_Service Manual Ford Engine Detector I1_198207.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.