Ford — Pump Reassembly

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. If wear plate (26) removed, secure replacement with hardware (27, 28)
2. Remove capscrews temporarily securing seal plate
3. Install same thickness pump casing gaskets (25) as previously removed
4. Secure pump casing to intermediate with nuts (24)
5. Adjust impeller-to-wear-plate clearance by removing gaskets until impeller binds
6. Add 0.012 inch gaskets to achieve 0.008-0.015 inch clearance
7. Reinstall rubber mounting isolators and leveling shims
8. Secure casing to base with hardware

Source: manual:OM-01610-02.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.