Ford — Oil Pan - Installation
Installation
From a Ford service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan WSG-1068 engine, Ford WSG-1068 engine
Before you start
- Mating parts must make contact to each other within 4 minutes and connecting bolts must be torqued within 15 minutes after applying sealant.
Procedure
- Install the oil pump screen cover and tube.
- CAUTION: Mating parts must make contact to each other within 4 minutes and connecting bolts must be torqued within 15 minutes after applying sealant.
- Use silicone gasket and sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6.
- Use metal surface cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-M5B292-A.
- NOTE: Be sure to tighten the bolts in three stages.
- Replace oil pan and bolts. Tighten the bolts in the sequence shown.
- Stage 1: Tighten to 2 Nm (18 lb/in).
- Stage 2: Tighten to 20 Nm (15 lb/ft).
- Stage 3: Tighten an additional 60 degrees.
- Install oil drain plug 11-16 Nm (98-143 lb/in).
- Tighten the front engine support insulators.
- Connect the battery ground cable.
- Fill the engine with oil. Use Motorcraft Engine Oil XO-5W30-QSP or equivalent meeting Ford specification WSS-M2C153-G.
- Fill the cooling system.
Specs & values
- 2 Nm (18 lb/in)
- 20 Nm (15 lb/ft)
- additional 60 degrees
- 11-16 FridayParts $36.10 Nm (98-143 lb/in)
Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.