Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›LL MP EXTENDABLE AXLE ELECTRO-PROPORTIONAL SERVICE MANUAL

Ford — LL MP EXTENDABLE AXLE ELECTRO-PROPORTIONAL SERVICE MANUAL

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Before you start

  • NOTE: Pull until both ends are even at

Procedure

  1. Place cylinder in a horizontal position.
  2. Stretch outthe replacement ropes and measure the free length of each rope. diameter and 705" (17.907 M) long. diameter and 411" (10.439 M) long.
  3. Lubricate all of the wire ropes (Chain and Cable
  4. Route threaded end of the extend wire ropes around the 12" sheaves (from top down) on cylinder housing.
  5. Attach clevis end of extend ropes to extend wire rope anchor block. This will leave threaded ends on the floor.
  6. Use wire ties fo hold the extend wire ropes that are not attached to the extend wire rope anchor in position for sliding boom into the base boom.
  7. Replace the anchor wear pad on fop of the tip boom.

Specs & torque values

  • A. Extend ropes should be 5/8" (16 mm) in
  • B. Retract ropes should be 3/8" (10 mm) in

Source: manual:89-103317.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.