Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›FIG. 25 Remove or Install the Float Assembly

Ford — FIG. 25 Remove or Install the Float Assembly

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

  1. 3. Remove
  2. the main jet with a jet wrench. A 3/V wide
  3. square point screwdriver may be used (Figure 26).
  4. 4. Remove the power valve assembly with a proper socket
  5. or a 3/8” wide screwdriver blade with a l/M” x 3/8” deep
  6. slot sawed in the center of the blade. The slot will clear
  7. the power valve stem and prevent damage (Figure 27).
  8. the disassembly of the carburetor body.

Source: manual:194-210 CSG649 Service Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.