Ford — Crankshaft Rear Oil Seal - Removal
Repair & overhaul
From a Ford service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan WSG-1068 engine, Ford WSG-1068 engine
Procedure
- Disconnect the battery ground cable (14301).
- Remove the flywheel (6375); refer to Flywheel.
- Use the Rear Crankshaft Slinger Remover and the Slide Hammer to remove the crankshaft oil slinger (6310).
- Use the Rear Crankshaft Seal Remover and the Impact Slide Hammer to remove the crankshaft rear oil seal (6701).
Tools required
- Rear Crankshaft Slinger Remover Amazon
- Slide Hammer Amazon
- Rear Crankshaft Seal Remover Amazon
- Impact Slide Hammer Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.