Ford — Camshaft - Installation

Installation

From a Ford service manual — check it applies to your exact model before use.

Browse Ford generators & specs →

Procedure

1. Lubricate the camshaft journals and bearing caps with Super Premium SAE 5W30 Motor Oil D9AZ-19579-A or equivalent.
2. Install the bearing caps in their original locations and the bolts.
3. Tighten the bolts in the sequence shown.
4. Use the Valve Spring Compressor to compress the valve springs and install the camshaft roller followers.
5. Lubricate the balance shaft journals with engine oil.
6. Using the index mark on the balance shaft, mark the corresponding teeth on the gear with chalk.
7. Position the balance shaft on the journals.
8. Align the balance shaft timing marks; align the chalk mark on the balance shaft with the camshaft timing mark.
9. Lubricate the balance shaft journals with engine oil.
10. Position the bearing caps in their original locations and the bolts; tighten the bolts in the sequence shown.
11. Install the intake manifold.
12. Install the timing chains.

Source: Ford service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Ford repair guides →